SEARCH SCALEAUTOMAG.COM

Enter keywords or a search phrase below:

09' DODGE CHALLENGER SRT8

3919 views
11 replies
1 rating 2 rating 3 rating 4 rating 5 rating
  • Member since
    February, 2012
09' DODGE CHALLENGER SRT8
Posted by 66383 on Monday, February 06, 2012 6:16 PM

NEED HELP WITH REAR METAL AXLE

  • Member since
    March, 2010
  • From: Midwest
Posted by High octane on Monday, February 06, 2012 10:45 PM

What kind of help? Did you lose the metal axle or what?

High octane

  • Member since
    February, 2012
Posted by 66383 on Tuesday, February 07, 2012 9:24 AM

put one wheel on one side and slide it throgh to the other side and put the other wheel on and it is like the metal axle is to short.

  • Member since
    December, 2010
  • From: houston, tx
Posted by avidinha on Tuesday, February 07, 2012 10:42 PM

Take the wheels off the axle, insert the axle into the chassis making sure it's centered. Make note of how far it sticks out on both sides and only insert that much into each wheel. You might need a dab of glue on each end to keep the wheels from falling off if the holes in the wheels are a little bigger than the axle.

I.Y.A.A.Y.A.S.

  • Member since
    February, 2012
Posted by 66383 on Wednesday, February 08, 2012 9:49 AM

The holes in the wheels are smaller then the axle?

  • Member since
    May, 2008
  • From: Newcastle, Sydney, Australia
Posted by Dr.Hemi on Wednesday, June 20, 2012 7:35 AM

Well here's a thought... Make the holes in the wheels... Bigger? 

  • Member since
    December, 2011
  • From: Medford Oregon
Posted by dragfreak on Sunday, June 24, 2012 9:48 PM

if you have a pin vise and some drill bits you can just drill out the holes to make them bigger like Dr. Hemi said

-Dragfreak

Outback Racing

14 years old

 

  • Member since
    February, 2006
  • From: the Netherlands
Posted by henri1 on Sunday, February 10, 2013 7:40 AM

just cut a piece of a old welding rod?

  • Member since
    February, 2006
  • From: the Netherlands
Posted by henri1 on Sunday, February 10, 2013 7:41 AM

or a new welding rod?

  • Member since
    February, 2006
  • From: the Netherlands
Posted by henri1 on Sunday, February 10, 2013 7:41 AM

remove the covering of a welding rod yes

  • Member since
    December, 2003
  • From: Menasha, Wisconsin
Posted by mcmainstribe on Monday, February 11, 2013 11:00 AM

I use TIG welding rod- it has no covering.

"I got me a '67 Chevy she's low and sleek and black. Someday I'll put her on that interstate and never look back." Steve Earle
  • Member since
    October, 2009
  • From: Central Ohio
Posted by pyrman on Sunday, February 17, 2013 3:10 AM

the original post was a YEAR ago! SurpriseHuh?Confused

Greg H

"Think of the fact that there's not one state in the 50 that has the death penalty for speeding...although I'm not so sure about Ohio." (The Cannonball Run)

JOIN OUR COMMUNITY!

Our community is FREE to join. To participate you must either login or register for an account.

FREE MONTHLY NEWSLETTER
SUBSCRIBER-ONLY CONTENT